/
[Test configuration] Difference between implemented BUS ports
[Test configuration] Difference between implemented BUS ports
Issue
What is the difference between the different ports in the bus access settings in the test configuration?
Solution
Each of these ports provides a different function. It is possible to combine the different ports with different tools making the setting much more generic:
Active Node: Is used for reading signals and messages. Messages can be sent in an additive (not cyclical) manner.
Manipulation: For manipulating signals and messages in rest bus simulation.
Monitoring: If monitoring of messages is to be allowed (minimum and maximum cycle time, number of messages received, CRC check, ALV check etc.).
Service: Will be used for service-based communication (SOME/IP) if a <SERVICE> channel has been selected above.
, multiple selections available,
Related content
[CANoe] CAN-FD bus connection settings
[CANoe] CAN-FD bus connection settings
More like this
[CANape] CAN-FD bus connection settings
[CANape] CAN-FD bus connection settings
More like this
[DTS] Cannot add DTS as a tool in test bench configuration
[DTS] Cannot add DTS as a tool in test bench configuration
More like this
[Test management] Test management service is not available
[Test management] Test management service is not available
More like this
[test.guide] ResourceAdapter cannot connect to test.guide
[test.guide] ResourceAdapter cannot connect to test.guide
More like this
[test.guide] Tips on attributes and constants handling
[test.guide] Tips on attributes and constants handling
More like this