Issue
I am facing problems when I try to connect a tool supporting CAN-FD with
...
ecu.test.
I want to configure my CAN-FD Port, but I have no idea where to find the data for the needed properties.
Is there any reference where I can get these entries from?
Solution
If some other software has already opened and configured the CAN interface,
...
ecu.test will use these settings.
Otherwise,
...
ecu.test has to configure the interface itself.
For that purpose, settings can oftentimes be copied from other tools (see below).
Make sure the bit rate
...
in ecu.test is entered in bit/s.
Where to find the CAN-FD settings in other tools:
...
| width | 4% |
|---|
...
| Note | ||
|---|---|---|
| ||
The screenshots will only help to find the settings, please do not use the numbers shown here. |
CANoe
...
CANape
| Note | ||
|---|---|---|
| ||
The screenshots will only help to find the settings, please do not use the numbers shown here. |
